Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm working on an established site with 4 4500 switches installed. All are being used as access switches. All are supporting IP phones authenticating via mab. All have an unauthenticated fallback configuration. It's multi-domain auth. As best I ca...
All,
I am attempting to determine how to remediate drops that I believe are caused by buffer failures on a 2921 ISR. The relevant interface statistics are:
Last input 00:00:00, output 00:00:00, output hang never Last clearing of "show interface" ...
Customer is receiving the following:
Alarm ID Module/Submodule Instance--------------- -------------------- ---------------1 missing_assignment WCCP/svc0612 missing_assignment WCCP/svc062
I found the following forum post which was very informative:...
All,
I've never done what I'm describing before, and because there may be proprietary information in the actual output, I have to be unfortunately vague, but here's the situation:
A customer noticed an asymmetric path through his BGP cloud while inv...
Customer had an ACE 20 reload... Here's the show version:
`show version`Cisco Application Control Software (ACSW)TAC support: http://www.cisco.com/tacCopyright (c) 2002-2006, Cisco Systems, Inc. All rights reserved.The copyrights to certain works co...
So how to make sense of the deployment guide? It contains information that primarily contradicts this statement, and includes a diagram clearly showing a traditional WLC.
http://www.cisco.com/c/en/us/td/docs/wireless/access_point/1850/hardware/guide...
So I got some additional information from the customer - he was quick to point out the 18 months of kernel uptime... and also noted that when the error occurred, this ACE, which was supposed to be the standby ACE, went active, so there were two activ...
That confused me too - on the 3650, the logs are timestamped GMT, on the 4500, the logs are timestamped with localtime. Don't blame me. I just troubleshoot this stuff, I don't configure it...
