Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Experts,Could anyone confirm if the following model support VLAN trunking? We are planning to replace a Dell PowerConnect 2724 switch which cannot properly talk to our Catalyst 3750-X. We have discovered that Dell switch requires GVRP enabled t...
Dear Experts,This summer we have purchased a Cisco NAC3315-500-K9 Appliance Server - NAC3315-500-K9. And we are about to start its deployment. But to our surprise, we have learned that in order to manage the NAC there is a separate hardware server an...
Dear Experts,I am trying to join newly purchased Aironet 3602i access point to our 2504 controller with no success. Here are the details:- All other models of APs we have - Aironet 1142 and 1130AG - got no problem to join the controller and are worki...
Dear Experts,I'd like to ask your advice on the following issue. We have two Catalyst 3750-X stacked switches serving as core/distribution switch for our small network. Both of them have IP base licenses. The goals is to setup 2 separate internet gat...
Hello,It is a question about licensing. We have two 3750-x stacked switches with IP base license. We need to upgrade them to IP services license. I read some where that it is possible to install IP serivces license to only management switch and no ne...
Hello Mr. Admani,Thank you so much for the super fast response! Really appreciate it!We have about 250+ computers and 150 iPADs at this point. Over the next two year course probably the number of computers will increase to 300 + and tablets to 200 +....
THANK you so much for the clarification.I would like to ask for your advice on the following. We are using two stacked Catalyst 3750-X (IP Base license) switches as intervlan router. Due to bandwidth limitations of our existing internet connection w...
Mr. Richard Burts,Thank you tremendously for the detailed explanation. Now I see how it can be done.I've tested setting default gateway that sits on different subnet for PC and Mac clients, and it is working ok. I suppose it will be the same for tab...
The odd thing was, all new APs get successfully associated with the controller and downloads new firmware. Then after rebooting it no longer able to join the controller. I have enabled debug capwap errors command on the controller and the output is t...
