Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, I have been playing around with both CAT9300V models in CML. I am trying to create a L3 port and setup eigrp neighbor between an IOSv device. when I create the L3 port I see the port in an UP UP state but I can not ping across to the othe...
I am trying out a solution using an ISR 829 with a cellular connection. This device will be a spoke in a DMVPN setup. It successfully connects with the hub and I am able to ping the Hubs tunnel address as well as ping between the sites behind the t...
Hello, I am trying to figure out why NATing with certain ports on the ASA is failing. It seems when I try to NAT ports 22 or 443 on the inside of my network I do not get successful connections but if I take and modify the NAT to a different port that...
Hello, I am new to the Firepower Threat Defense products. I am trying to set up an external NAT that will forward ports to my internal network. I have tested the NAT rules on high ports such inside-x.x.x.x:8000 <-->outside-x.x.x.x:8000 and it seems...
Hello, I have a wan site that has 2 routers with 2 wan links(separate carriers) and 2 switch stacks(1 stack of 5 and 1 stack of 4).
In the pictured diagram each router is configured with a port-channel connected to the stack below. This connection wi...
CIMC setup is typically accessible only during the boot process (via a BIOS key like F8 for CIMC config during POST). So: If the server is already running the OS, you won't be able to access CIMC config without a reboot.There may be a pull-out servic...
Cisco AnyConnect's Start Before Logon (SBL) feature establishes a VPN connection before logging into Windows. This feature is only available for Windows platformsI believe you can use the following on the Mac though:Automatically Start VPN Connecti...
you could try the following:no ip nat service sip tcp port 5060no ip nat service sip udp port 5060ip nat inside source static udp 192.168.0.7 5060 <Outside_IP> 5060 extendableip nat inside source static udp 192.168.0.7 10000 <Outside_IP> 10000 extend...
yes the port is up/up on both sides but I am unable to ping from 9300 to IOSv. I switched it from 9300V Doppler to 9300V SiliconOne and it seems to work now. not sure what was going on
