Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,Usually, I configure real server and their default gateway is inside a vlan in the own ACE module.I configure the real servers, serverfarms and the probes and works fine.Now I have to configure a load balance where the real servers are outside...
Hi all.I'm having a problem to modify SNMP community in NX-OS.I already have a community defined in my Nexus 7K:snmp-server community xxxx group network-adminI want to add 1 more community with the following commands:snmp-server community yyyy roBut ...
Hi all,In the last days I had a problem with a lot of embryonic connections in some IPs and I want to control the number of embryonic connections.I would like to see embryonic connections of some IP but I'd like to do this with SNMP and I´m looking f...
Hi Nael,I'm logged using TACACS.With the same user that i used in NX-OS, I can configure, ASAs, routers and switches in the datacenter and even in the NX-OS I can configure something but modify the SNMP community I couldn't.I don't know if there is s...
Hi Mike.Thanks for your response.I was trying to to do this check by SNMP but acoording to you its not possible. I needed to check the embryonic connectons only to a few IPs.Then I will do this check by scripts logging the output by CLI like Perl/Exp...
Hi Mohamed,The MSFC configuration you will not need to translate. This configuration is always in IOS mode and it will be the same in the native mode.I have some translation to your CatOS commands:set password xxxxxxxxx set enablepass xxxxxxxxx You w...
Hi,I already used the CatOS to IOS translation:Link:http://www.cisco.com/cgi-bin/Support/CatCfgConversion/catcfg_xlat.plIn this link, you have to put your CatOS configuration or you can also upload your file.There are some commands that the tool can'...
