Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Cisco Prime Infrastructure 1.3 - Creating custom TACACS+ Attributes / Shell Profile for ACS 5.3As titled, currently under Admistration> Users, Roles & AAA > User Groups > Export Task List under Cisco PI 1.3All the attributes is "=" which is mandatory...
Hi Guys,I'm currently facing this issue where the CSM 4.2 Event Viewer keeps getting this error message:"Eventing Service is unavailableEvent Management is disabled or the service failed to startPlease check if 'Event Management' is enabled from Conf...
Hi Guys,Can the ASR1004 RP-1 act like a switch? where i can create SVI,vlans, and switchport mode trunk or access on a particular ethernet interface?i tried to create an SVI but it failed. the IOS-XE im using is "asr1000rp1-adventerprisek9.03.05.00.S...
Hi Guys,I tried to build a port channel between 2 interfaces from 2 different fex with the same Parent switch but failed to do so. The parent switch which i have tested is the Nexus 7010 and 5020.N7K-01(config)# int e101/1/1,e102/1/1N7K-01(config-if...
Hi Michael,Yes i'm using a single N7K/N5K which is connected to two Nexus 2Ks.I'm not using VPC for the server connection.With this setup, Can the N2K build a LACP port with 2 different FEX to the server?
For the Nexus 5000. below is the error i getint eth 103/1/1 - 2N5K-01(config-if)# channel-group 2000command failed: port not compatible [All HIF member ports not in same pinning group]
