Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Trying to setup some POTS lines on FXO ports for the first time, using CallManager 5.1.3, and a MGCP 3845 for the gateway.Both inbound and outbound work perfectly with these POTS lines on an analog phone.I've been able to get inbound calls working pe...
We're currently running CCM 5.1.3, and just updated to the latest SCCP Phone Firmware, using 7941s and 7961s. For people who are a member of a hunt list, is there any way for them to tell if a missed call was to them, or do the hunt list? Right now, ...
We're getting ready to enable Auto-Registration on our CCM5.1.3 system. Is there any reason to not setup/enable it during business hours? I realize it'll cause a bit of a CPU/Network bandwidth hit when the phones start to register, but anything else ...
I've been tasked with checking our existing CCM 5.1 system to see if our VAR implemented any type of QoS at all. I've been going through some packet captures of calls, but I'm not really sure what to look for. I know there's multiple methods and ways...
Is there any way to get CUPC to display your status as "On the Phone" when you're using a secondary line, rather than what is set as your Primary Extension? So far I've been unable to figure out any way to do this.
Well, another issue now. I have both ports (two POTS lines) set to loop start in CallManager - but when one tries to dial out, it continues to say it's set for ground start. I've tried deleting it, then waiting for a couple minutes, and re-creating i...
The DN range we're going to use for it isn't used anywhere else, should we still have it blocked off? Or with no potential for overlap, could we use an existing partition/CSS?
We're still on Unity Connection 1.2, doesn't appear that feature is available. Very cool that they added that though, I'm sure we'll use it once we upgrade.
