01-19-2009 11:41 AM - edited 03-15-2019 03:37 PM
We're getting ready to enable Auto-Registration on our CCM5.1.3 system. Is there any reason to not setup/enable it during business hours? I realize it'll cause a bit of a CPU/Network bandwidth hit when the phones start to register, but anything else beyond that?
Thanks in advance!
Solved! Go to Solution.
01-19-2009 11:56 AM
ok, then that discards overlapping. so the only chance that someone could dial it without knowing the number would be by mistake. if you don't think anyone could end up dialing one of the new numbers by mistake then you can use the existing partition/CSS
HTH
java
if this helps, please rate
01-19-2009 11:44 AM
only make sure that at that time the phones are auto-registered in a partition still not available to regular users and no overlapping to avoid calling issues
HTH
java
if this helps, please rate
01-19-2009 11:47 AM
The DN range we're going to use for it isn't used anywhere else, should we still have it blocked off? Or with no potential for overlap, could we use an existing partition/CSS?
01-19-2009 11:56 AM
ok, then that discards overlapping. so the only chance that someone could dial it without knowing the number would be by mistake. if you don't think anyone could end up dialing one of the new numbers by mistake then you can use the existing partition/CSS
HTH
java
if this helps, please rate
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide