Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Have a pix with Internet connections on 2 different interfaces in two different subnets.Would like to have a default route with metric 1 pointing to Internet router on one interface, and another default route with metric 2 pointing to Internet router...
We wish to have 2 default routes. One points to a gateway on the outside interface network. The other points to a gateway on another interface, but has a higher metric. If the first default route gateway is not accessible, we want the traffic to g...
Greetings allI have two new 3550-12g running 12.1(19)EA1c IOS.I am trying to connect both switches using inbuiltRJ45 10/100/1000 port (# 11, 12). The trunk works fineif i use 100Mbps connection crossover cable. The same does not work with 1000mbps.Am...
Greetings All,i want to connect the two PBX trunk line using data circuit. The primary circuit between the locations is DS3 and backup is 2T1. Is it possible to run G711 (uncompressed) when DS3 is active and when it's down i.e. when 2T1 is active t...
Greetings All,I am running 12.1(20)E. When I try to configure ethernet dlsw The command(config)#bridge 5 prot ? dec DEC protocol ibm IBM protocol vlan-bridge vlan-bridge protocolWhy I am not getting option for IEEE ? Am I missin...
Well If I hardcode the speed at 100Mbps it works.If I use straighthrough cable with speed/duplex auto(default config) why It's not autonegotiating to 1000Mbps ? you are right I might have to use differentcrossover for gigabit.thx
Dragos,Thanks a lot. Can you point me out some good tech docbesides doc cd if it is avaiable ?I am more concerned about the tracking of primary line.again thx a lot.Ajit
Russ,I really appreciate your inputs.I double checked the maximum-path statement. its there. I will check out the matrics and cost of all six interface and publish it on Mondayhave a nice weekendAjit
From opposite sidesh ip ro 10.69.2.0Routing entry for 10.69.2.0/24 Known via "eigrp 1", distance 90, metric 2181120, type internal Redistributing via eigrp 1 Last update from 10.64.1.110 on Serial1/2, 1d07h ago Routing Descriptor Blocks: 10.64...
Here it goes from one sidesh ip eigrp neiIP-EIGRP neighbors for process 1H Address Interface Hold Uptime SRTT RTO Q Seq (sec) (ms) Cnt Num6 10.64.1.105 ...
