Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I currently use SNMP to monitor the bandwidth on a 7200 and would like to monitor the CPU utilization as well. Is there a MIB I can use to send this info to the NMS?
Hello,I currently have radius (Linux FreeRadius) working to authenticate admin access to the AP.Is it possible to authenticate user web requests through the 1200 AP using a radius server and the stock IOS? The current version is Version 12.2(13).I a...
Currently I have a 7200 Series Router configured in a point to point connection with my ISP's Juniper router. I have another 7200 router with the same config turned off waiting in case the primary fails. I would like to make use of the offline router...
Hello,I have a PIX 501 with two interfaces. I am trying to setup a webserver behind the internal interface.I have a single public IP assigned to the interface.global (outside) 1 interfacenat (inside) 1 0.0.0.0 0.0.0.0 0 0I tried static (inside,outsid...
Hi, I have a question about this document. If you have two access points both with two VLANs (secure and not so secure) each how would you configure the other switch port? Each switch port would need to be configured as a trunk, correct? Thanks
Hi Rick,Currently we use static routes. There are two networks behind two firewalls and they are both connected into a 'DMZ' switch. The router is also plugged into the 'DMZ' switch. All the devices in the 'DMZ' are configured with public IPs all of ...
