About jason.williams

Remove Shared Profile Components · 11-25-2009

Some Shared Profile Components were installed for Cisco Security Manager. We're trying to do some testing and I need to remove these from our ACS server.Does anyone know how I can do this?Thanks.Jason

jason.williams · 11-24-2009

I have a few questions regarding CSM's ACS integration.1) What's the difference between using ACS mode and non-ACS TACACS+?2) I've been testing with ACS mode and it seems that there is a delay in the time a device is added to ACS and CSM's ability to...

jason.williams · 11-20-2009

I need to have a SPAN port forward VLAN tags. This is on a 6509 running 122-18.SXF15a.Here's the current configuration for the port and the monitor session:interface GigabitEthernet2/11 description Connected to Gigamon-1A port 9 switchport switchpor...

jason.williams · 11-10-2009

I'm trying to set up an authorization set to restrict users to certain commands. However, it seems like it works for some commands, but not for others.In ENABLE mode, the auth set seems to work properly. However, once I get into CONFIG mode, it no ...

jason.williams · 10-20-2009

I'm having a strange issue. We have a router that is connected to an OC12 and it is sending ingress netflow data on all layer 3 interfaces.The thing that I'm seeing is that the bandwidth utilization will go over the bandwidth of the OC12. I've seen...

jason.williams · 11-25-2009

So, can I set CSM to non-ACS mode and still use ACS, through TACACS+ to control user authorization as well as access rights (helpdesk, approver, etc.)? I have already configured ACS mode for testing, so all of the CSM settings have been installed in...

jason.williams · 11-23-2009

I'm going to bump this in the hopes that someone can help.From what I have read, in theory, all I should need to do is have the destination port trunked. However, when I do a capture with tcpdump off of that destination port, I'm not seeing the VLAN...

jason.williams · 11-10-2009

Adding aaa authorization config-command worked.However, I've got another issue (I think).Other groups have "none" selected for the auth sets. When I log in as a user in one of those groups, I get an access denied error when I enter ANY command.The o...

jason.williams · 11-10-2009

That might be it, the command isn't there.I'll try it and let you know if that was it.Thanks.Jason

jason.williams · 10-20-2009

In this case, it's a 6509-E.I did configure both.active flow timeout is set to 1mls long aging is set to 64

Member Since	‎06-24-2009 05:06 AM
Date Last Visited	‎08-18-2017 03:55 AM
Posts	18

User Statistics

User Activity

Remove Shared Profile Components

Cisco Security Manager - ACS Integration

Maintain VLAN Tagging through SPAN destination?

Authorization Set Not Working Properly

Inaccurate Netflow Data?

Re: Cisco Security Manager - ACS Integration

Re: Maintain VLAN Tagging through SPAN destination?

Re: Authorization Set Not Working Properly

Re: Authorization Set Not Working Properly

Re: Inaccurate Netflow Data?