About weymannpe

weymannpe · 04-30-2009

Hi all,I have a weird problem when specifying the ntp source interface. The command disappears after a relaod! The funny thing is that, when I specify the source interface with the ntp server togther "ntp server a.b.c.d source <interface>" the comple...

weymannpe · 07-18-2008

Hi all,I am using a Cisco 871 IOS router with IOS software release 12.4(20)T (Adv.Security) and the following configuration for SSL VPN access.aaa new-model!aaa authentication login VPNCLIENT localaaa authorization network VPNGROUP local crypto pki t...

weymannpe · 05-29-2008

Hi all,I changed the severity level for Guest User alarm conditions from Informational to Warning to receive Emails about that conditions.In the received is also mentioned that the received email was suppressed up to 30 minutes."E-mail will be suppre...

Guest User SNMP Traps · 05-29-2008

Hi all,I run into a confusing behavior. When I use the Lobby Amabassador to add/delete an Guest User with limited life time I get a SNMP Trap (thats what i want) but when I add an Guest User with unlimited life time I never got a SNMP trap, wether th...

weymannpe · 05-08-2008

Hi all,I get a lot of the following syslog error messages from 3 of my 4 WLCs (two WiSMs).Error message:ethoip.c:342 ETHOIP-3-PKT_RECV_ERRORI searched at cisco.com and I found the information to use the bug toolkit or open a tac case, but I didn't fi...

weymannpe · 04-30-2009

You are right!Thank You very much!Peter

weymannpe · 06-02-2008

Hi all,I'm using WCS version 5.0.56.0.I can see an entry under "Monitor" security tab, so i can remove the client (so far so good).But if I use the search as Marcelo described, I never get an entry.Does anyone of you have the same problem?Did I make ...

Re: Guest User SNMP Traps · 06-01-2008

Hi krengasw,thanks for your answer.Do you know the BugID to this issue.Many thanks!Peter

weymannpe · 05-09-2008

Hi dennischolmes,after your post I checked the mobility group configuration on all four controllers, and indeed, there was a inconsitency in the configuration. The WCS couldn't see the mismatch, because the settings between the WCS and the controller...

Member Since	‎04-25-2007 05:10 AM
Date Last Visited	‎08-18-2017 03:55 AM
Posts	9

User Statistics

User Activity

NTP source command disappears after reload!

AnyConnect VPN on Cisco IOS router problem

Email suppression

Guest User SNMP Traps

WLC Syslog error message

Re: NTP source command disappears after reload!

Re: Listing / Removing clients from "Client Exclusion Policies"

Re: Guest User SNMP Traps

Re: WLC Syslog error message