Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Any body knows How to collect S/N of AP 1000 Series (Not Physicaly)... Is there any way to collect from Controller.?Any Posibility to to configure SNMP community in APs. Then i can use CNAC Tool to collect S/N.
Hi,I am Cisco WiSM consists of two Cisco 4404 controllers which is installed on the 6503 Switch. I am using Mac Address based authentication for clients to get connect.When i am adding a new client's mac address to one controller, it is not reflectin...
I have to configure an Access Point 1311 in remote site to be asociated with WLC in Central site. I have followed the following prcedure to do the same. 1.Configuring an AP in H-REAP Mode. a.Connect AP in the switched network; configure the port und...
Hi all,One of my AP 1010 got a static IP in vlan 110 Range but Controller is in Different(default) Vlan. Due to this its not getting registerd with WLc. Anybody can suggest any procedure to remove that IP from AP.