Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi team,I have a Cisco ISR4331/K9 router, and my objective is to disable SSH version 1 on the device.I have already configured the router to use SSH version 2, and I expected that enabling SSH version 2 would automatically disable SSH version 1.Howev...
Hi team,
I just want to ask whether the Router C1121-4P supports the SSHv2 feature.Could you please provide the Cisco reference documentation for this?
Hi team,
I have ordered 2x PWR-RGD-LOW-DC but IE-4010 uses PWR-RGD-LOW-DC-H.So, Can I use PWR-RGD-LOW-DC for IE-4010 Switch ?I saw in the Cisco documentation that it says:"The power supplies listed are recommended for new installations. The older PWR...
Hi David Ruess,
This link refers to SSHv2 support for the ASR 1000 series, not for the Cisco 1000 Series Integrated Services Routers, right?Could you please provide the Cisco 1000 Series Integrated Services Routers reference documentation for this?
...
Hi Pieterth,
My phone is registered to CUCM and is running Enterprise firmware, not MPP. Is there any way to disable Web Access directly on the phone itself without going through CUCM?
Thanks
Hi Elsen,
I asked Cisco's AI, and it said that all LAN ports, except the WAN ports, are only Layer 2. To configure Layer 3, do I need to set up an SVI on the router?
Thanks
