Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,I have RME 4.0.5My Manager said there is a possiblity to trigger a mail when a device take new backup.say example when there is any change then the device will be archived and create new version.Now when its creating new version, will it send ...
Hi Experts,As of now we have single internet provider to my DC and we have public IP pool (195.34.56.0/24 leased from old provider)Now we take another internet provider for redundancy and we bought one public IP pool (193.141.24.0/24)I have two my ro...
Hi All,We have two Servers, they are indeed connected to the same Cisco 3560G and recently configured the setup, but when making speed tests between the machines the actual speed is much lower - from 150 mbps to 400 mbps depending on file size and wh...
Hi AllI would like to enable port security on my core switch for security reasons and to avoid unauthorised access.Can some one please tell me if there is any other pros & consWhat steps should I take to avoid future troubles.Thanks in advance.... R...
Hi All,I suddenly noticed that my one of the IOS-Firewall where all NAT configuration done.When I verified the log I found below logs....Router uptime is 33 minutesSystem returned to ROM by error - an unknown failure, PC 0x6025C7E4 at 09:37:05 UTC Th...
Hi Giuseppe,Oh....great...!I have small doubts.If we accept a default route from providers, will it be not accept like whole internet routing table like that?If that is not the case, I heard sometimes the whole internet routing table will land on our...
Hi Guiseppe, Nice to see your reply and good explanation .As of now the BGP multihoming configured and maintain will be by Provider itself.Yes, I would like to point only default route to provider GW.say 0.0.0.0 0.0.0.0 197.28.56.1I hope the ip as-pa...
Hi Giuseppe,Thanks for your response.I too have the same document, what I would like to request you is if you have experienced in BGP multihoming and I want your best suggestions how to go towards success on this.Can you provide me If you have any ki...
Hi All,I checked the speed and duplex settings and speed is 1000MB full duplex, no errors found on interface.Actually how we noticed the low speed between the two systems which are connected on two different gig ports on 3560 Switch. Yesterday there ...
Hi Vishwa,Please try to add ACL like below...deny ip "DHCP ip range" subnet anyThen permit some set of pool for IP phones.ORWhy don't you change Obtain IP address automatically to Static for those PC's which you want connect in those portsRegards,Nai...
