Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi.I woulk like to enable SNMP in a Cisco 3750 Catalyst switch. I am doing it with Cisco network assistant 5.I configured a community string, after I enabled trap manager but here I don't know if I must to write IP address of the switch or ip address...
Hi.I used to change dial number in phones dialing a number and after following operator instructions. I would like to know what my administrator did in CCM to permit me do that.I use CCM 4.1.Thanks.
I had installed Ciso TSP on a Windows XP to dial number from Microsoft Outlook 2003 and it does not work.When I open a contact from Microsoft Outlook and I click on dial contact button after I need to select in line config my Cisco IP phone but It do...
Hi. I am doing a sh mac-address-table in Cisco Catalyst 3750 switch and I don't know what's the meaning of Po1 in the type of port.Anybody can say me it?. This is a line of cmmand output.11 0013.c3bb.4185 DYNAMIC Po1
I have CCM 4.1 and I provide MOH form CCM server.I checked user hold audio source and network hold audio source in phone, line number and device pool and all it is ok.I don't what happen.
I am sorry to say you that your post and the Edison post are not helpfulI repeat your procedure from first switch where this MAC appear and I could discover the last switch in ehterchannel group but It isn't wanted MAC there.
My core switch and a voice gateway is in the etherchannel group how I can see with commands that you say me.I find thi MAC in core switch and now in type of port of this MAC it shows Po3 but I don't know where I must to see know because this is my co...
Hi.I entered sh mac-address-table address 0013.c3bb.4185 command in my core switch and now port is Po3.I don't know where I must to do know to find it because this is my core switch
