Hi,I am trying to get 802.1x port based authentication working on a cluster switch member. All the switches are 2960 series veriosn 12.2 (44) SE2. Only the cluster commander has an IP set and that is configured on the radius server (Windows 2008 NPS)...
Hi,We currently have 1 6509 switch with two WS-SUP32-GE-3B modules working in Single Router Mode Redundancy. Can I get another switch with same configuration and run HSRP for better redundancy?What are my options when its comes to using the WS-SUP32-...
Hi,If there is only one switch acting as a server in a VTP domain, what happens if this switch is turned off? Do all the other client switches loose their vlan information? ThanksSalil
Hi,We are planning to move all our VLANs/routing from the 5509 RSM to our new 6509 with 2 SUP32 modules.I found out that we can run itin only Single Router Mode redunduncy. Are there any good links for configuration examples. Is there anything that w...
Hi,Here is the syslog outputPIX-6-302013: Built outbound TCP connection 429209865 for private:10.251.1.65/80 (10.251.1.65/80) to inside:10.3.0.113/1298 (10.3.0.113/1298)PIX-6-110001: No route to 10.251.1.65 from 10.3.0.113I get this error even after ...
Hi Ganesh,Thanks for the link. The configuration I am using works perfect if I use it on a standalone switch. It proves that my Switch config, radius server config and client config is working. Its only when I try to use the same switch config on a s...
Hi Jon,I am using the same thread so that I dont have to explain the scenario again. To keep things simple can I stick to the SRM on the two 6509 switches and use HSRP for L3 configuration. This way I dont have to upgrade the IOS or CATOS to support ...
Thanks Jon. Your post has clarified a lot of doubts. Adding on - Each SUP has 8 fiber ports. To have proper redundancy I should then be connecting SUP1 Chassis 1 (S1C1) to S1C2 and S2C2 and similarly other ports as well. Or can I use Etherchannel for...
Hi,I have read that the only supported MSFC redundancy option for SUP engine 32 is SRM which we are running currently. I would like to know if the SUPs I have support double chassis and dual SUP engines and MSFC'sThanks,Salil
Hi,PIX OS version 6 to ASA OS ver 7 - As long as your config does not contain conduits there should not be any problem.We had a similar migration recently and we had the complete config ready on the ASA first. We tested the basic access-lists and tra...
