Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HelloApologies as this origional thread was posted on the wrong board. I currently have an IPSEC link between two sites up and running. However there are now calls to add an additional site. Therefore there will be one central VPN router provideing...
Hello I was just curious if there is actually a default if you have the key exchange set as below:-crypto isakmp policy 1authentication pre-sharecrypto isakmp key xxx address 10.x.x.1Would this make the exchange in plain text?If i adjust the setting ...
I have set up an encryption link at work and everything works fine apart from one application. It works without encryption but when the encryption is on it does not. The encryption session is up and active and so i wont go into detail about the conf...
Many thanksI bounced the interface a few times and it worked. I still did take out the unneccessary command and as you all say it works The one thing i am a little worried about is a constant error messege in the logs:-*Aug 4 06:15:16.823: %SYS-...
Hi and thanks!!Ok so the encryption and authentication are a combination of DES and Diffie-Hellman group. My concerns in this area are that the other end of the link will be mobile and moving from site to site. When using MD5 a PKI certificate is cr...
Hello SunilIt worked by setting the df-bit override to clear. However does this mean that the router will just fragment to whatever size is needed? If this is the case then it would be more preferable than setting the MTU with the ip tcp-mss-adjust...
