Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, can someone tell me how to tell a catalyst swicth (maybe 3750) to use only DCSP or COS for queueing. sometimes when i use DSCP, i notice some COS only marked packets goes into queue based on default COS mapping.is there a way to tell the switc...
Hi Guys,there is a small detail i am not getting right. how do you add more vlans to your FWSM after the initial one you do on the switch.e.g firewall vlan-group 1 10,15,20,25firewall module 1 vlan-group 1now i want to add more vlan interfaces to the...
Hi Guys,I am seen funny behaviour with synchronization in bgp. sometimes when i turn synchronisation off and advertise prefixes through network statement and my IGP (OSPF) doesn't have those routes, BGP refuses to advertise the prefixes. sometimes, i...
Hi Guys,can anyone give me an idea of how a B2B network design should look like? a url link to a desing example or a network diagram example will be appriciated.cheers
Hi guys,will be gratefull if someone can tell me if there is a bandwidth limit on a single fwsm session. i.e is there a limit on the maximum bandwidth (throughput)allowed per session on the fwsm?
many thanks. but i am not talking about trust port. i am talking about output queues.when i configured output queue mapping based on DSCP, i see packet in queues i have not configured anything for. and i know this queue is matching COS values mapping...
Hi,Jithesh is right. if you use the command "sysopt connection permit-ipsec " all interface acls will be bypassed by vpn traffic. if you are using os 7.x and greater, there is a new command under the group policy for each VPN that can effectively fil...
Hi,I noticed a number of things in your config.1) in the DHCP config, you need to exclude your router IP address for the pool that your router will be leasing out to its clients.from the global config, please put the following command to exclude the ...
i am not sure this is supported. pls take a look at this link.http://www.cisco.com/en/US/docs/switches/lan/catalyst3750e_3560e/software/release/12.2_44_se/configuration/guide/swuncli.html#wp1009453i will suggest you configure a SPAN (mirroring) inter...
Load balancing effectively to the internet using two ISPs can only be done using BGP.ASA does not run BGP and as such you can't achieve that with it. but ASA can be used to automatically switch to second link if the main link goes down. pls checkhttp...
