Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,Is it possible to secure the data transfer between ISDN connection using encryption algorithms or some other way with cisco routers at both end?ThanksYamin
Hi,I need to downgrade my cisco IOS from version Version 12.4(15)T7, RELEASE SOFTWARE (fc3) to Version 12.4(11)T2, RELEASE SOFTWARE (fc4).How can I achieve that and what is all I need to do that.Thank youYamin
Hi, I have a problem doing SFTP through ISDN, ISDN connection is not staying active throughout the duration of the file transfer, it drops after its timeout value even if data transfer is in progress and file transfer break at that point, this happen...
Hi,I have a problem doing SFTP through ISDN, ISDN connection is not staying active throughout the duration of the file transfer, it drops after its timeout value even if data transfer is in progress and file transfer break at that point, this happen...
Hi, I am using ISDN, on initiating the call I am getting following error, it appears like the call is initiated for a while (1 or 2 secs) and then hangs up with message "Normal call clearing".I appreciate any suggestions, as why this problem is occur...
I am having the same problem with the version Cisco IOS Software, C850 Software (C850-ADVSECURITYK9-M), Version 12.4(15)T7, RELEASE SOFTWARE (fc3) on the other hand this command is showing up fine in the version Cisco IOS Software, C850 Software (C85...
Hi,Dialer list I have on my side is, access-list 112 permit ip host 10.10.10.9 any, all the traffic is orignating from 10.10.10.9. By one way connection I mean to say that call can be initiated from my side only (i.e from 10.10.10.9 which is my sourc...
Thanks for your reply Rick.This connection is a one way connection initiating from my side only, SFTP connection bring up the call but call drops after its dialer timeout value. It is my end of the connection dropping.Thank youYamin
Hi,Thanks for the reply.I want to perform NAT on destination IP addresslets say destination IP address hitting external interface is 1.1.1.1 and I want to translate that to 192.168.1.1.How can I perform that.ThanksYamin
