Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi guys,I have a problem with connection beetween a Router and Cisco ASA 5510 conection through VPN.The originator VPN have this configuration in router ===================================access-list 181 remark SIAEaccess-list 181 permit ip host 200....
Hi guys!!I have a big trouble resolving a issue with ASA in Active/Active and VPNsFirst I have this escenarioBecause in Active/Active implementation I cannot use any VPN function, I have to put a Router (1841) behind the ASA arrangement to operate as...
Hi,I'm trying to find out if it's possible to integrate 3rd party WiFi SIP phones to the Unified Communications Manager Express v8.6.I found these licenses:NameCatalog NumVendorDescriptionUnit PriceSW-CCME-UL-3PSIPM=SW-CCME-UL-3PSIPM=CiscoCallManager...
Hi,I'm working on a technical offer. I need to validate some IEEE and RFC standards compliance for CISCO1941/K9. I've allerady got the Data Sheet and the Feature Navigator documentation. Is there any other official document where I can get this detai...
Hello Jennifer,The big problem is the remote end is an ISP router and they don´t want change the access list as you suggest me. In this escenario the ISP only want to create an IPSEC tunnel beetween the Public IPs, and permit in my side, to access ot...
Hello Jennifer,I change the configs with all suggestions, but I cannot connectI included all the VLANs from side A to generate interest traffic but don´t have any result. I make many test. When ping the loopback in side A (10.172.10.5) from equipmen...
Hello,When edited teh display information i don´t care about put the NAT but is configured in the ASA (side A), i correct the UDP issue but cannot connectThe crypto ACL only include the loopback network and the side B major network, for test, you can...
