From all the readings I've done, it looks there're only 2 -ugly- ways to achieve this:
1- reload the secondary switch (operational as primary) or
2- flap (shut/unshut) the peer link on the secondary switch (operational as primary) -I'm assuming role ...
Hi,
I've got the exact question, in my case it's site to site vpn tunnel terminating on the outside interface. The tunnel is up and running, I allowed RDP from local host to a remote host and it's working perfectly ok (just allowing RDP on the inside...
Hey Sebastian,Had the same issue, which I just managed to get it resolved.When you insert the modem, the router will create an Async interface for it lets say Async 0/1/0then all what you've to do is:chat-script DialOut ABORT ERROR ABORT BUSY "" "AT...
Had a very similar issue, which I managed to fix, just type the below under the interface config mode: power inline neverWS-X4648-RJ45V-E is a PoE module which doesn't work well with legacy 10Mbps devices.Rate it in case it fixed your issue
Hi Guys,Had the same issue.. worked it out:boot system flash sup-bootdisk:s72033-ipbasek9-vz.122-33.SXI1.binor any other image you're currently runningmake sure your boot section in the running config looks as below with no extra lines:boot-start-mar...