Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi There:
i have a simple setup. 1 x N9372TX-E, the 48 x 1/10G Base-T will connect to servers, and 6 x QSFP ports will be used for uplink to upper layer network equipment.
all the 48 x 1/10G base-T port will have QOS marking policy, and on uplink por...
Hi Guys:i am a bit confused now.,I read the document, http://www.cisco.com/en/US/products/hw/switches/ps708/prod_models_comparison.html#~tab-e and http://www.cisco.com/en/US/prod/collateral/modules/ps2797/ps11878/qa_c67-648478.html[Q.I have Cisco 67...
Hi guys, need you advise.i am going to purchase 2 Cat6506 with Sup-2T to run VSS, since all the uplink/downlink are 10G based fiber, and no other 1G connection is required, i really dont want to buy 1G line card.Of course, ePAGP will be enabled, but ...
Hi All:I notices i can't not ssh out to another device from my router. SSH in from my client (putty) works fine.and not access-list attached to vty with out direction.transport output allI found this problem happened on my ASR1002 with "asr1000rp1-ad...
Hi there:I have a question.For example, i have a MSE3310 with 1000 client track license installed, what if i have 1001 clients, what will happen?Thanks a lot.
Hi Jen C.this option is only available in quote, but normally we will do up the BOM first which is the configuration. now what i do is COPY and manually delete. it is prone to mistake.tks
