Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I had setup a static route in a complex network to influence the path it would take. I decided to use the loopback address of the destination router (which is 2-3 hops away), not the next hop. It was by complete accident that I did this (but se...
During an installation, we plugged a Ruckus wireless bridge (powered by a PoE injector) into G0/0 on the 1941. The port status remained down/down. We then tried connecting it to G0/1. Again, the port status remained down/down. We took another wir...
I have a couple of remote sites with AIR-LAP1041N-A-K9 AP's in a H-REAP Configuration. It works great, except if the WAN connection goes down. I realize it has limitied functionality at this point, and that is not my focus. The problem I am having is...
I have callmanager 7.1.2, and we use extension mobility with user device profiles. We are moving to a new building with different room numbers, and I wanted to update line 2 to correspond to the new room. I am assuming BAT is my best option, but d...
I have callmanager 7.1.2 that I am using with 7940's and 7960's. All phones have a 5 digit number on line 1. We are moving to a new building with different room numbers, and I wanted to update line 1 to correspond to the new room. I was looking for a...
unfortunately I do not have access to this router right now, but I do have the running config. The second interface config reflects nailing speed and duplex to 1000/Full. Same results on both ** Origional **interface GigabitEthernet0/0 description XX...
Hey Alessio,No, we are using a straight-through 568B cable. And as stated "We took another wireless bridge, plugged it into G0/0 and the port changed to up/up status within a few seconds." So cable "type" has also been verified to work-Brian
Ok, I figured out what was wrong with my 7960. Somehow my line appearances were setup as DN's without any numbers associated, and that's why my import failed.Thanks again for your help
