I use this tool to decode the preshared key from the .pcf files. Works like a charm. http://www.unix-ag.uni-kl.de/~massar/bin/cisco-decode
... View more
http://www.cisco.com/en/US/tech/tk1077/technologies_tech_note09186a008010edb8.shtml “Note: Cisco IP Phones 7902/05/12 have a different code base from the Cisco 7940/60. Consequently, there is a delayed reply to the network ping with the 7902/05/12, but not the 7940/60. Note: Also, for Cisco Unified CM, this behavior exists and the ICMP will be throttled in order to prevent DoS attacks.
... View more
For all SCCP and SIP firmware upgrades from firmware release versions earlier than 8.3(3) to version 8.5(2)SR1 or greater, you must first upgrade your firmware to version 8.5(2). Once you have upgraded to version 8.5(2), you can upgrade your IP Phone to version 8.5(2)SR1 or later. Refer to the Firmware Versions in this Release section of this document to determine the firmware load provided in this Service Update. For all SCCP firmware upgrades from firmware release versions earlier than 8.3(3) to version 9.2(1) or greater, you must first upgrade your firmware to an intermediate version (8.3(3) - 8.5(2)) then upgrade to 9.2(1). http://www.cisco.com/en/US/docs/voice_ip_comm/cuipph/firmware/9_2_1/english/release/notes/7900_921.html other than this there shouldn't be any compat issues. .divin
... View more
What I intend to do is, PSTN calls 3000 hits inbound POTS dial-peer, then use a translation rule change the called number to 113000 then this matches a voip dial-peer pointing to this router itself Now the call is a h323 call You can do the max-conn . use transalation-profiles to change the 113000 to 3000 and route the call to final destination. If you hit the max-conn then the call will just disconnect Or just ask the provider to send only X number of calls inbound! /divin
... View more
From the top of my head, You can loop the call as a h323 call then send it out to the IP Leg Will need a couple of translation patterns.! Let me check /divin
... View more
Can you make a test call from the IP Phone then the rigthfax server to the same number. Collect the debugs. debug voip ccapi inout debug ccsip messages on both the 2811 and the CUBE router. It looks like a dialplan issue. Check your dial-peers else give me these debugs and the relevant dial-peers. (probably the entire set of dial-peers on both routers.) /divin
... View more
You can try show dialplan number to get which dial-peer would the outgoing call match. Else run debug voip ccapi inout Search for "outgoing" in the debug. /divin
... View more
