Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Cisco 4451-X ISR router is running IOS XE Software version 03.13.00.S. I am trying to run the command "debug ip policy" on the router to verify if the traffics are policy-routed correctly, but I get no output displayed on the router for the debug co...
Hello,Does anyone know where to find some good documentation on Cisco licenses for UC applications upgrade?I couldn't find anything from the Cisco websites.Specifically, I want to know what do i have to purchase for an UCM upgrade from one major vers...
Can someone help me with this problem that i am having with Windows desktops not being able to perform a tracert to an IP address outside of the company's network?From behind the PIX 515E ver 7.0, i could successfully perform a traceroute on any rout...
Can someone help me with this problem or point me in the direction to get more information on this problem? I would appreciate it.I have a network with 2 Catalyst 6506 and 6509 switches. Two of the devices connected to the switch is not behaving no...
Hello,Has anyone seen this problem before or know how to configure fragmentation on FR properly? Any help is greatly appreciated.I have 3 offices with FR links through my ISP MPLS networks. The central office has 1536 kbps link and the other 2 remot...
Thanks for the info. However, if Cisco router uses UDP traceroute, then how come i see ICMP type 11 in the PIX when i performed a debug icmp trace? Not only that, my inbound access list does not allow UDP.In addition, when I tried a utility that i ...
I debugged the icmp packets and it showed the ping packets were received by the other end of the router when the packets were less the fragment size of 640 bytes. When the ping packets were more than the fragment size of 640 bytes, there was no outp...
I tried setting debug ip icmp and performed an extended ping but nothing happened with the debug. No message or anything.Here is the outputs of the show frame frag.This output is for the router at the remote site. fragment size 640 ...
Because the FR link is the production line, with fragmentation on, i cannot send traffics across the link so i had to disable fragmentation. I'll try to enable fragmentation again tonight and post the results for you. Thanks for your help.JD
