Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I am trying to add snmp config on my Cisco ISE 3.3. i have configured below commands#snmp-server enable#snmp-server contact XXX#snmp-server user XXX.... while i try to add snmp host in version3, it requires remote engine ID. And as per my snmp te...
I have an AP 9176 which is not updating the regulatory domain.The AP join tag has a correct config. other same model APs on same switch are able to update the country code and regulatory. error on wlc %APMGR_TRACE_MESSAGE-5-AP_COUNTRY_CODE: Chassis 1...
Hello ,Can someone explain the impact/affect of command "request platform software process core ios chassis active r0" on cisco 9800 WLC ?Will there be any impact on connected users?
WIth C9800-L-F-K9 model, i have a Anchor and foreign setup with mobility tunnel formed between them. It is observed that if i switchover anchor WLC (HA-SSO), the mobility tunnel does not come up. I tried changing mobility mac to static.the WMI gatewa...
Thanks for the response Julian,Tried this already, but it didn't work.Here what I observed is command "show snmp-server engineid" will give you the local engineID, and as per command we need remote engine ID.(Possibly of remote SNMP poller)?ISEnode(c...
Hello, I have a 9800 chassis with 17.15.3 version and trying to enable Wi-Fi 7 on CW9176i access point. On an existing WLAN with dot1x auth, what all changes i need to make to enable Wi-Fi 7? any useful document?
After several checks, the issue was located on firewall end. After disabling the offload on fortinet, tunnel established as expected. thank you all for the efforts and suggestion
