Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We are currently in the process of migrating out vmware infrastructure from HP to UCS. We are utilizing the Virtual Connect Adapters for the project. With the migration we also plan on implementing the cisco nexus v1000 in our environment. I have ...
I have a setup where I have 2 seperate data circuits, a primary and a redundant connection. In the event of the primary connection going offline, I need to secondary connection to pick up without a configuration change.I have an application server t...
I have sucefully ran the DMA and loaded it on my new CM 7.1 server. I have also sucefully loaded my subscriber. So I am sitting with my new environment running CM 7.1(3).I have administered CM 4.x for the past 5 years and was comfortable enough to ...
I have a user that is trying to get to www.defender-usa.com, but everytime the url show to be unavaliable. I can resolve the address, but everytime I do a ping or traceroute, it keeps trying to route to my IronPort. I am running a Catalyst 4506 IOS...
I am running CallManager 4.1(3)sr4b and am having an issue with certain phones updating with the DST. Mainly my 7940s. I have applied new firmware and reset the devices to no avail. Every other phone I have seems to have updated the time just fine...
In my past setups I have used 1gig nics. Of cource with UCS the nics will be 10gig. My setup includes6 UCS chassis with 42 200M2 and 6 230M1 blades with the virtual interface adapter. Our storage is EMC Symetrix and we are using FCoE.I think I hav...
I have no control of the network outside the firewall, the inside routers are set with HSRP with Router 1 being the primary router.Here is how a specific vlan is configured.Router 1interface Vlan X description Server Subnet ip address 10.10.10.1.2 25...
The firewalls are not setup in a cluster, they are standalone ASA 5520s. The routers are 4500 running HSRP on the all networks (10.10.10.4.x, 10.10.10.x). The issue is more with the destination route through the firewalls. If I request traffic fro...
The weighted routing does not work for my setup. I just missed a deployment with the current configuration. I have set it back to just a direct static route, with the need for a manual change in the event of a failover to Circuit 2.
This would work if I could ping the gateway of the circuit. The address available to me is the same for both circuits, so setting up EEM technically does what I need, I just have no way to setup a variable for the switch. I am more looking for a wa...