Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
My LAN network abruptly stopped connecting to the internet. I have no idea why and it's frustrating. Some devices cannot even connect to the LAN network talk more of the internet. Attached here is the config. I use a cisco 1941 router, which i...
hello,
i have a NAT failover configured on my 1942 router. (The config file is attached to this post). Main link is ISP1 and secondary link is ISP2. The secondary link is connected to one of the EHWIC switchports at the back of the 1942 router. The c...
Hello,
I need some advice and, if possible, links to resources i can use to implement this. Thanks in advance
I want to create a hotspot for a network i manage at a hotel, such that all checked-in hotel guests can login with a room number and a syste...
I have a cisco 1941 router connected to a switch, and a modem. I suddenly noticed a huge slow down with the internet connection. It happened very abruptly. I did an isolated test and noticed i was getting the usual bandwidth from the ISP but when co...
Hello,I'm trying to set up NAT load balancing with two ISPs on my 1941 router but the router has only two WAN ports and 4 EHWIC ports (which are basically switch ports). One of the WAN ports is currently being used for the LAN SIDE and the other WAN ...
Hello,
The command "spanning-tree portfast bpdufilter " in global config mode still gives the same "invalid input detected" error message.
I have also removed "spanning-tree portfast bpduguard" but that didn't change anything.
Here's some info about...
Hello,
I tried that command already and It doesn't seem to work. I get the message "% Invalid input detected at '^' marker." each time in enter that command.
