Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
A week or so before the maintenance or upgrade of Sandbox, I was able to adjust the MTU on the CSR1000v to do an OTV lab and was successful. Since the upgrade, i have not been able to do so. I can change the MTU on the interfaces but it has no real ...
Hello, I am having an issue accessing my reserved lab. Login/password failure. Worked with a hitch last night but not with new lab this morning. Any help would be appreciated. Thanks
Hi There, We are trying to engineer the following scenario: We have 2 HQ sites. The first is a primary data center and the second one is a DR site. We have parallel MPLS networks from 2 separate providers. We have points of presence into both MPLS...
What makes a route show up as an external eigrp route vs an internal eigrp route other than the obivious; distribution from another routing protocol or another AS? What triggers the external flag?
I am trying to use the clientless webvpn to access citrix apps via NFUSE. I get to the NFUSE page but when I try to login to the app, I get an error message stating that I have not opted to trust the certificate from that particular site. Any ideas w...
UPDATE:I am actually able to get the OTV adjacency to form between my two ASR-1001x's. The issue is with attempting to ping across the tunnel. I can see the OTV arp-nd-cache for the nodes as well as the routes to each on the OTV routers but can't pin...
Must have just been something with that particular lab. I stopped the initial lab and reserved another and it is working as expected. Thanks for checking it out. Mike
Thanks everyone but I actually figured out what I was missing shortly after I posted this question. I was looking at a couple of route table entries that were showing up as external eigrp routes even though they were in the same AS. I completely miss...
