Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I want to check the line number of switches and routers configured in my network or how I'll check line number for any new router /switches going to configure in the existing network.Do we have any general formula to calculate the line number for Ci...
My recommendation -Keep F5 in DMZ and will surely improve the performance.L3 ---FW ---F5 in DMZ --- lan segment..... whatever traffic which need policies and filter ,will go via DMZ only
My understanding - you are all set to go with Cisco Viptela Services.Approach - segregate all the sites with there priorities - P1 - sites need resilency and load balancing P2:) resilency and transit 3 remote site with single WAN link ..DC - Vcontr...
Architecture -Cisco Viptela have following components 1:) vOchestrator 2:)vBond 3:) Vcontroller 4:)vEdge connect each other as a overlays using underlay media like LTE,MPLS ,4G etc .they use OMP protocol,TLOC to identify each other locations and peer...
I am not sure if I understand this question correctly..but here is the fact
If two switch connected each other via default access port and two PC connected both end are part of vlan x and in same subnet ,will ping each other.
Now example - pc1 - 10...
OMP automatically redistributes the following types of routes that it learns either locally or from its routing peers:
ConnectedStaticOSPF intra-area routesOSPF inter-area routes
To avoid routing loops and less than optimal routing, redistribution of...
