Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
Please can someone tell me if it's possible to setup a Guest SSID in NAT mode (similar to the Meraki feature) without having to use VLAN tagging etc...
Thanks
Hi,
Please can someone help me to figure out why this configuration doesn't work.
As soon as I make port 24 on the HP a member of the trunk setup on the HP pings go down and comms are lost.
Port 22 on the Cisco 3560X is connected to port 24 on the H...
Hi,
I'm having a problem with a 887va trunk port connected to a HP procurve switch.
VLAN1002 doesn't want to pass any traffic, can someone advise if I have missed anything?
Config 887va
interface FastEthernet0 switchport trunk allowed vlan 1,2,1002...
What I'm trying to get around is having to advertise another network from our MPLS router.
Would I being able to create another vlan on the router, tag this for the guest SSID and NAT this through the advertised default gateway?
Thanks, all working now. I must have got mistaken and thought that vlan 1 needed to be untagged to act as native vlan. Tagged ALL the vlans on the trunk now and works perfectly.
Hi Hozaifa,
There is no CLI on the 1820 but the trunk is setup as Static not Dynamic not should not use LACP
Dynamic—Dynamic trunks use the Link Aggregation Control Protocol (LACP, IEEE
standard 802.3ad). An LACP-enabled port automatically detects t...
Just to expand on this, we use VLAN1 as the management vlan on subnet 192.168.128.0/24
The Cisco has an IP of 192.168.128.3 and the Procurve has an IP of 192.168.128.86.
When we make the HP a member of the trunk I can no longer ping 192.168.128.86
