11-25-2016 06:13 AM - edited 07-05-2021 06:09 AM
Hi,
Please can someone tell me if it's possible to setup a Guest SSID in NAT mode (similar to the Meraki feature) without having to use VLAN tagging etc...
Thanks
Solved! Go to Solution.
11-25-2016 08:18 AM
Yes... that is what you would have to do. Your router will have to perform the NAT.
-Scott
*** Please rate helpful posts ***
11-25-2016 06:51 AM
Sorry just to add, hardware WLC 5508 and 1602i AP's, site routers 887VA's
11-25-2016 07:10 AM
Mark,
The Cisco controllers do not support NAT and thus you will have to create a desperate vlan and tag guest traffic.
-Scott
*** Please rate helpful posts ***
11-25-2016 07:32 AM
What I'm trying to get around is having to advertise another network from our MPLS router.
Would I being able to create another vlan on the router, tag this for the guest SSID and NAT this through the advertised default gateway?
11-25-2016 08:18 AM
Yes... that is what you would have to do. Your router will have to perform the NAT.
-Scott
*** Please rate helpful posts ***
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide