Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,I have a number of ports to be forwarded to an internal server. All works fine until I apply my ZBF config.Anyone able to cast an eye over my config to suggest how I forward a single port from the internet (dialer 0) to a device on vlan 20?i.e...
Folks,I have 2 x Cisco 887VA routers connected to different internet links. They both feed a Cisco 2960 switch with runs my Business and Home Network. I have one network printer which I want to printer from any vllan. At this point I can ping the pri...
Hi folks,I am trying to balance wireless features vs cost to implement a Cisco Wireless solution across my small office and home network. Any guidance would be welcome. The current setup is 2 x Cisco 887VA router providing internet access to a Cisco ...
Hi Folks, I am looking to replace my ASA 5510 with a 5512-x or 5515-x and looking for a little advice to ensure I get the right version to enable future learning/protect my small network. Essentially I have my CCNA R&S and looking to start either my ...
Hi Folks, I have posted my config below for a little advice/suggestions.This is 1 of 2 Cisco 887 routers which feed into a Cisco 2960 switch were I have mapped the access ports to VLANs as below. I have a few questions as I had planned to use Ether C...
Folks, Success! I have solved the problem and posted my working config below in case anyone is spinning their wheels. Essentially the problem was that I was inspecting outbound traffic and passing inbound traffic without inspection. This miss match w...
Thanks RJI, I have updated the config on my original post to show my NAT rule is correct - ports route to host 10.10.20.5. Apologies I missed correcting that. The progress is that I now see the counters increase when using port checkers on port 32400...
RJI, your are right. The correct port is 32400 and I have copied the ACL below / updated my original config. Apologies for misleading your as I was blanking out my ports in use and made an error. Lesson learned for the future. I did this because when...
Follow-up;The ZBF zones have to be applied to the vlan's to provide internet accessMy ZBF does not all single ports to route from Outside (Internet) to devices on the local network despite showing PASS on the WAN-TO-LAN policy. Work in progress, cont...
Hi Rick, ZBF was suggested to me on this forum which I deployed a config that works fine. Maybe a little rough around the edges as I belief I may have left an unused access group/policy name in place. An attempt with an access-list stopped https traf...
