What I have:
I have two ISPs and I want to load-balance between both providers. I have two ASA 5525X and two ISR4431 routers. I have an ASN already with a /24 address space.
What I want to do:
Use all equipment and load balance out of both ISPs to ...
I am looking at moving to a 10GB backbone for a small campus of about 70 switches that go in to a single modular 4510. I was looking at the Catalyst Catalyst 4500X-24-ES model and using two in the core of the network. There are three additional build...
I've gotten very odd behavior with one of my switches. When a device that uses PoE is connected to port 1, the switch reports that it detected the device on port 25:
Jan 8 03:05:12.208: %ILPOWER-7-DETECT: Interface Gi1/0/25: Power Device detected: I...
We are considering upgrade our 4510 series modular platform with a 4500X model with 10GB connectivity to 5 other buildings. Does anyone have a similar configuration running? We have about 65 switches in total connecting in to the 4510.
Hi, Each ISP will give me a point to point connection from them to my routers. The routers will have a private IP address on each interface that connect in to switches on my LAN network. The routers will perform GLBP and advertise a virtual gateway o...
Hi, Thank you for your reply. I have been thinking that maybe I was making it more complex than what it needed to be. If the design would be each ISR router interface 1 going to each respective ISP advertising the AS number I have, the interior inter...
I do not have an option to RMA the device. It is odd because I had another line in the config to provision as switch 2 and when that was in everything worked fine when the active switch was switch 2.There would be a list of interfaces from g1/0/1 thr...
Wireshark will probably show the contents of the exchange between the phone and switch. There is likely some flag set to on in the packet for voice or some other value so the switch knows the device connected should be on the voice vlan.
