Hi all,Radius configuration was rolled out on our devices and we can access them via AD credentials 100%Now i tried to create a seconday Radius Group with a singe user to only be able to make our backups for our backup server,thus only allowing 1 com...
Goodday,please assist.I have a cisco 4321 router with IOS isr4300-universalk9.16.09.04.SPA.bin installed.It does not support crypto isakmp configuration ?Which IOS can i download as i searched but have not been able to get the correct IOS.RegardsPie...
Hi.I am battling to get my local username and password to login to my routers and switches when tacacs server has been configured already.It doesn't allow you to connect.I need to have this option as to be able to login to the devices when the acs's ...
Hi,I am battling to configure Line Telnet on a Cisco SG300-10P switch.I am in config mode and enters line telnet,but when I do a show line,telnet still are disabled...what am I doing wrong.Pieter
HiI configured a Cisco WS-3750G-24 Port as transparent mode on VTP version 2.It only allows for 1005 vlans.Which tool can I use to configure more Vlans on the device,do I need to upgrade the software?RegardsPieter
OK,so maybe i misunderstood the config as i created the 2 server groups on the 1 server:aaa group server radius GTCGIJRADDV001 - this was for AD Authentication aaa group server radius Radius1 - this was to be the secondary group for read-only userI r...
Hi,Is only 1 Radius server,but there was 2 seperate groups configured on the server Group 1 for full access with specified credentials and a group 2 for read-only access with 1 specified user credential
as for now,if I remove the ip tacacs source interface and tacacs-server host and key line,then I can log in to the router or switch only.
seems that if the tacacs server is accessable and online you will not be able to use local id and password
