Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I have been trying to get a virtual IP address (Vlan 13 Gateway) to route out the internet.Everything is working fine from Sw1 and 2 as far as connectivity to the internet is concerned.SW3 gets DHCP addresses assigned fine and can ping everythin...
Hi I am having some issues setting up a 2821 to pass internet traffic from a internet router to a layer3 switch.the switch and a pc connected to the switch can ping the outgoing interface on the router but not the other side of the link.The router ca...
Sorry I ment to do this awhile back.Here are the current configs for the router and SW1. there are other switches which I havent added here. TS_NBN_RTR1#sh run
Building configuration...
Current configuration : 2690 bytes
!
version 12.4
service time...
Hi All, Sorry for the delayed update. Turns out the original config works and all the issues stemmed from the ISP router being a POS. I was about to wipe the configs and start again as stuff that had been working wasn't etc. Not sure weather to repl...
Hi, @David Ruess I removed the the Stub entries and no change.M02@rt37 I havent tried your idea yet as I currently dont have SW2 setup for Vlan 13, I am testing the connections as I am setting up. I will try turning it into a non HSRP setup and test ...
The 2821 is doing well a speed test shows 50mb/s throughput down and 19mb/s up which is was the connection is shaped to by the ISP. Nat has been setup on the router now and that I have the basic setup done I can work on setting up Sw2 which is connec...
Thanks everyone for the Help. I can now reach the internet when I plug my laptop into a port. I will post the working configs shortly for anyone in the future as a reference. now to fully understand all the steps that were rquired.
