Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a new Cisco Phone system, we are using CUCM and at this particular site have a 4321 ISR . The fax line is plugged into port 0/2/0. Inbound faxes come through but when sending outbound faxes it rings one time then cuts out. On the receiving end...
I have a VPN I am setting up for our phone company to allow access from our main office to our satellite to connect their equipment. I am using Cisco ASA's at both end. I have the tunnel up but cannot ping across the tunnel. Probably should mention t...
can someone please point out why my traffic isn't going through my vpn? I'm assuming I am missing something in NAT. I need the traffic that is outlined in my cryptomap ACLs to go over the IPSEC VPN and it currently isnt. Below is my config. The end ...
I am trying to configure a VPN between my Cisco ASA 5506 and a local hopsital that is using a Juniper device. below are the settings they gave me for the VPN and i have configured the cisco to the best of my knowledge but when i run command Show Cryp...
I have a cisco sg500-52 port running in a stack config with another cisco sg500. I cannot get console access into the box. i have tried turning off the secondary switch and trying to console into the master. i have tried multiple different baud rates...
Maybe my access-lists are misconfigured? I am finding some things on the cisco forums that say they should look more like this
access-list outside_2_cryptomap extended permit "Local VPN IP Range " object-group " remote object group"
I am current...
Here are the results from side 2 back to side 1, looks like the traffic is going out the WAN and not staying internal. i have delete the last two octets for security purposes.
Ochoa2# ping 192.168.42.20Type escape sequence to abort.Sending 5, 100...
Yes my apologies, that isn’t that actual IP address. When I was replacingIPs with random ones for security reasons I accidentally put the same IP infor interface and default gateway. In real config they are different andalso correct.
IKEv1 SAs:
Active SA: 2
Here is the output of the sh cry isa sa
Rekey SA: 0 (A tunnel will report 1 Active and 1 Rekey SA during rekey)Total IKE SA: 2
1 IKE Peer: 6.6.6.6 Type : L2L Role : initiator Rekey : no State : MM_ACTIVE2 IKE Peer: 7.7.7.7....
