Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
- Cisco Community
- :
- About ppavlovich
Stats
Member since
12-09-2010
15
Posts
5
Helpful
0
Solutions
11-25-2015
Hello - I have some 2960x stacks that are dropping their 10g connections
back to their main closets....
08-02-2012
Thanks for all your help. I ordered two new octal cables and it worked.
Both cables I had were bad. ...
07-27-2012
I basically re-did it, and put only the basics on. Current
configuration:!version 11.3service timest...
07-25-2012
It's funny that I get the same response to a connected device that is
turned on and turned off. It's...
07-25-2012
Cabling has been checked and rechecked. The connected devices I can get
to by consoling in normally....
07-25-2012
Hi all, Don't have too much experience setting up a 2511 term server.
When I try to connect to a dev...
06-04-2012
This was indeed an ISP issue, and the configuration was correct. Thanks
for everyone's help.
05-14-2012
dot11 syslog!dot11 ssid Internal vlan 1 authentication open!dot11 ssid
Guest vlan 50 authentication ...
05-14-2012
The AP is attached to a 2960, then to a 3560. The DHCP pool for guest
access is on the 3560 and I ca...
05-10-2012
Hello,I have two SSIDs on an Autonomous Access Point, that goes to a
2960 switch, that connects to a...
08-25-2011
Can someone explain to me the exact purpose of, when creating an
instance of BGP on a router, when t...
Public Statistics
| Date Registered | 12-09-2010 06:13 AM |
| Date Last Visited | 09-04-2020 07:10 PM |
| Total Messages Posted | 15 |
| Total Helpful Votes Received | 5 |
