Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Greetings. Basic question here --- I have two 6500 Core switches setup with HSRP, however, they are not VSS. They are two separate switches. Downstream I need to connect two Nexus 9k's.
My plan:
On the Core side, two ports in chassis 1 setup as a LA...
I have two 9500's in virtual stackwise setup. Stackwise links are twe1/0/27 and 28. When I plug the 40Gb cable into 1/0/27 on switch 1, I get the following errors from console:
Jun 20 16:18:58.480: %NIF_MGR-6-PORT_CONNECTION_STATUS_CHANGE: Chassis 1 ...
Hello all, Does anyone know what the average failover time is for hosts dual-connected to a pair of Nexus 9k's (vPC configuration)? I recently upgraded four Nexus 9k's, one at a time, and found some hosts had lost connectivity for about 6 seconds dur...
Hello, I'm going to be upgrading some Cisco N9K's to current gold-star code. They're currently setup in VPC configuration. I've upgraded Nexus switches before, but i'm just wondering if the switches being in VPC configuration would have any impact. C...
I'm attempting to configure fast hello on two copper interfaces on my 9407 chassis' running SVL. It won't give me the option to do so under config mode: Switch#conf tEnter configuration commands, one per line. End with CNTL/Z.Switch(config)#int g1/1/...
With a single switch/router/host, your links make sense. But I have two core switches that are separate, not VSS, or one logical switch. It will have to be two links bundled from one nexus to one 6500. And another two from second nexus to the second ...
One more thing for clarity - on the Nexus side I would have two links from Nexus 1 going to Core 1 and two from Nexus 2 going to Core 2 - just basic LACP port-channels, correct?
Thanks Perkin. I have a scheduled maintenance window, so downtime is allowed. So you recommend just reloading both chassis at once via "redundancy reload shelf", correct?
Asking the group...Once boot variable is changed, config-register is changed, config is saved and it is time to reboot --> should I just reboot the entire VSS (both chassis') with redundancy reload shelf, or one at a time? Thanks,Shameer
