Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have 2 different sites that are both using PPP multilink to bundle T1's. The sites are identical regarding hardware and ISP's. Each site has 1 T1 provided by Sprint and 1 T1 provided by BellSouth. Each site connects back to our main site that ha...
Hello,I have a site to site vpn setup between a 7206vxr and a 2801. Everytime I bring the tunnel interfaces up, the machines at the remote end begin to experience extreme latency. I have tried adjusting the bandwidth on the tunnel interface and dec...
Using the configuration below I have created a VPN tunnel between 2 sites. The tunnel is up and passing traffic encrypted however, it doesn't look like ALL traffic between the two sites is being encrypted. I say this because the counters don't matc...
Hello,I have 2 T-1's coming into a single 1841 router. On the 1841 I have NAT configured for the internal traffic destined outbound. The router is also running CEF.My goal is to load share across the two T-1's. Will the following configuration wor...
Hello,I am trying to poll my device interfaces using SNMP to gather statistics. I have found that when issuing the "clear counters" command via CLI that it doesn't clear the SNMP counters.Does anyone know if it is possible to clear these counters wi...
Thanks for the reply!The slowness occurs as soon as the I perform a "no shut" on the interfaces and the tunnel comes up. Unfortunately, due to the number of hosts, I can't change the MTU size on each host. I tried changing the MTU on the router int...
Thanks for the reply. I did as you suggested (except for the loopback interface configuration which I will do tomorrow). Looking at the Netflow information, it reveals that all traffic is going out of the Multilink 1 interface rather than the tunne...
We use "Lantronix" terminal servers with great success. They configure very easily and simply hang off of a switchport.Here is the link to their site:http://www.lantronix.com/device-networking/external-device-servers/Brian
The customer has 2 T-1's going to 2 ISP's. They wanted the traffic from the 192.168.1.0/24 network to go out of the Fast0/0 interface to ISP1 and the traffic from the 192.168.2.0 network to use the Fast0/1 interface using ISP2. The traffic had to b...
