Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi everyoneI have a 2924XL switch that has amber lights on its first 4 ports. The switch does shows only 20 FE ports in its show version, but the ports are configurable (but do not work) from the CLI. no specific configuration has been done on the po...
We have 7905 phone that we are installing wiht CCM4.1. I have set up two CCM servers, one productional and one for testing purposes. the problem is that the new phones i try two put online via the production servers do not upgrade. they keep rebootin...
HiDoes any one know or is there a tool to calculate the bandwidth consumption of ciscoworks for LMS. I know that microsoft has a tool for MOM. does cisco has such tool or is there any info on that from cisco?Thanks
I am getting a lot of this error on my CM version 4.1(3). I have checked the database and its less than 20megs. I have used the reconfig_cluster command with no luck. what might be wrong?
I tried the default factory setting on the hones with no luck, however I did manage to find how to make the phones stop rebooting. I disabled CDP on the phones and they came up and upgraded with no problem. after that i enabled it again and no proble...
Hithanks for the reply, unfortunitly I dont have access to that link I only have a guest account, I have tried to reset the phones on the networks setting menu, is this what you mean? if so that didnt hel either. any ideas?thanks
I have an as5350 with np60 module and 2pri e1 module. I checked this on cisco (did not say anything on nm60) and all I could find was isdn incoming-voice voice command.thanks
we have callmanager installed with AS5350 as our gateway. H323 isconfigured for this setup. Is there a way to stop this from hapening on the gateway itself?thanks