Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello there,You can try a few simple checks:Test different baud rates like 38400 or 57600.Set flow control to none in your terminal.Check the console cable and adapter, sometimes the cable is the problem.Look at the AP LEDs to be sure it is fully pow...
If the AP model supports standalone/embedded controller mode, you can run it without a separate WLC, but many enterprise APs need a controller to provide full service. So it depends on the AP type and software. In most cases, no WLC = very limited or...
If the kernel package is truly missing and you’ve got no TFTP/USB/XMODEM available in that ROMMON, there’s realistically no in-place recovery left. In that state it usually comes down to offline reimage of the eUSB DOM or an RMA. You might try TAC ju...
It does sound like ISE is expecting a client cert and not getting one. Usually this happens if the switch trustpoint isn’t properly bound to the DTLS profile or the cert isn’t valid for client auth in a way ISE accepts. I’d double-check the trustpoin...
