Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello all!I have the following setup for VoIP at my place of business (educational):1 - UC520 (VLAN 100)1 - ESW-48P PoE Switch (VLAN 100)1 - ESW-24P PoE Switch (VLAN 100)24 SPA502G Phones (VLAN 100)1 Valcom SIP IP Speaker - VIP-410 (VLAN 1)1 Valcom S...
I have a UC520, two ESW-500 switches and 26 SPA502G phones. Half of the phones are in one building and the other half are in an adjascent building that is connected with a Aironet 1310 Bridge. The bridge is set on the side with the UC520 and one ESW ...
We just installed a uc520, an ESW-520 48P and 26 SPA502G phones. The phones are all PoE and we have a limited number of drops around our location, so there are multiples places where the PoE port is the only data port in the vacinity. However there a...
Okay, so some serious weirdness.I went into the Port Security settings tab and clicked Edit on eth1. That is where the first connection I am having issues with is located.So what I did was uncheck the "Lock Somethingrather" tab and changed the max co...
Okay, so after some digging, i found that it is pretty easy to change to Smartport roles, but none of them will allow me to natively connect more than one device and still maintain use of the phone. The other choices were more or less to allow routin...
