Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I need some help with the connection between a ASR1001 and a Catalyst 2960G. The interface on the ASR won't come up, and I am pretty sure this is a configuration issue but I can't figure it outAt first, both interfaces wouldn't come up, but since ...
Hi,I'm trying to configure a RSPAN with multiple source ports on multiple switches and 1 destination port.On the first switch I have :Session 1---------Type : Remote Source SessionSource Ports : Both : Po...
Hi,I'm tring to configure a Cat3750 Stack in 12.2(53)SE with 2 vrf but the usual ip vrf vrf-name command does not exist.Has it been moved or removed ?ThanksStéph
Hi,I have several clusters defined, all switches (commanders and members) are in the DCR with their own IP address and are managed by RME and DFM as standalone hosts.In Campus Manager, only the commanders are shown, I've tried to put the members in t...
Hi,Is there way to create a vlan interface that wouldn't be routed, like on a layer 2 switch ?I'd like to use this interface on a layer 2 isolated network, only to managed the c3750 by ssh.Thanks.
Thanks for your help,In this case i'm trying to monitor 2 servers in HA, the first is on a remote switch and the second is on the same switch then the sniffer.I want the traffic form both servers on a single sniffer interface (ie gi0/7 of switch#2).W...
The answer is already inside the IOS 12.2(35) :switch1(config)#ip vrf test % VRF-Lite is not supported in the IP Base feature set and will be removed in future releases, please refer to www.cisco.com for the feature sets that support this feature
Thanks for your answer,But I still can't understand what's happening.I have 1 opperationnal c3750 stack running in 12.2(35)SE5 ipbasek9, sdm template desktop default with 2 VRFs configured :switch1(config)#ip vrf ? WORD VPN Routing/Forwarding insta...
