Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Community,i have a little problem since we installed a spare 2950 Catalyst running IOS: c2950-i6q4l2-mz.121-14.EA1a.bin.I have configured a static IP Adress on interface VLAN 1.I assume that a switch with a configured static IP-Address does not...
Hi community,right now we have 2 1841Router with IOS-AdvSec 12.4(19) in use.The 2 Routers are connected via Serial 0/0/0 and Serial 0/0/1 and do ip load-sharing per-packet. In the future we would like to encrypt this connection. Which configuration s...
Hi Cisco NetPros,i have a short question:We are using several Cisco1841 routers. The show clock command gives the output which i expect (Time = NTP time).But the show log command give the output with a time stamp from UTC (i have to add 1 hour to get...
Hi NetPros,since i am remotely checking the hardware on a bunch of old Cisco75xx Routers i have problems to find out which hardware is really in use.sh diag shows me the older Cisco Board Part Numbers, for example: 73-2571-02.Is there a tool or a lis...
Howdy,its kind of tricky with the ICT.We use WinVista: you have to start the IE as an administrator - then it shoud work.I don´t think its an account problem - since you use the same credentials as for the dynamic configurator.So - you should have fu...
Hi,1. Solution: delete the old image (directory) recursively:switch# delete /force /recursive flash:xxx-name of the old image2. Solution: change the boot parameter and leave the old image on the switch:switch# boot system flash:xxx-name of the new im...
Hi Jack,no chance. The used Version 12.1(14) unfortunately doesn´t support this command.I can´t find the reason why this switch gets and takes an IP from the DHCP.Thank you for your help.
Hi Jack,i get nuts about this issue...I followed your suggestion and cleard the "ip dhcp bindings" and "ip dhcp server statistics".But i think both of these commands relate to the situation when my Switch is acting as a DHCP-Server.My problem is that...
Hi,don´t forget to use sfp+ on your 10GB-modul!The Gbit modul only supports Gbit SFPs.The 10Gbit modul supports 4 sfp´s or a maximum of 2 10Gbit sfp+´s.If you use other than Cisco´s sfp+ (cisco is not necessarily needed) be sure to ask you service co...
