Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have an ACS SE 5.4 and I need to change the IP address. When I console into the sever and I try to change the IP address it just stays the same. Tried stopping the ACS services first, go into config mode, interface Gigabit 0, ip address x.x.x.x m...
I am using SDM for the first time to set up a 871 router. There is a predfined policy that just seems counter intuitive. It is found in the Firewall and ACL section and is called sdm-permit. It is applied from the out-zone to self. This is the con...
I have a Aironet 1231 with IOS 12.3(8)JEB1. I have enabled SNTP, but it still shows the time and date that are configured manually. How do you disable the manual time setting?
My SPAN port, 4/47, doesn't seem to be receiving any of the packets that are being received by port 4/48 (note input packets in the show commands below.) What am I doing wrong? DO-MDF-CAT6509#sh mon sess 1Session 1---------Type : Lo...
Hello Bill,Thanks for your response. I found that the NTP server I was pointing to was not an "Authorized" server and the time never syncronized. I pointed to an authorized server and the time sync'd. Thanks again for pointing me in the right direct...
Thank you for the clarification. It looks like I was trying to do something that's not possible. I think I found the solution though. I created a loopback interface. Even though this is a virtual interface, like a vlan, the loopback is always up and ...
