Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Friends,
Could any one clarify me what is the difference between WRR BW Ratio & Queue Limit Ratio on Cat 6500 IOS.
Interface GigabitEthernet2/31 queueing strategy: Weighted Round-Robin Port QoS is enabledTrust boundary disabled Trust state...
Hi Friends,
Could any one help me in understanding the values in show queueing int gigx/y which shows as 100 in WRR BW ratio and Queue Ratio.
Does the 100 in BW is 100 Mb or 100 Buffers ?
Queue Id Scheduling Num of thresholds ----------------...
Hi Mrityunjay,
Does all the PE routers in the same IBGP Mesh ? If yes probably that could be the reason as routes learned via 1 MP-IBGP cannot be exported to another.
Regards,
Pandu.
Route refresh capability consumes the bw by sending messages and the entire adj_rib_out table when ever there is a change in the inbound policy. Where as soft reconfig inbound , applies the modified policy on the routes which are stored separetly on ...
