Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
I'm trying to create a DualStack Environment over our existing IPv4 DMVPN multipoint GRE Tunnel. The Spoke Router can ping both HUB Routers wihtin the same tunnel. So i think the tunnel is working. But i'm not able to exchange the routes via EIGR...
Hello CommunitySince ca. 2 - 3 weeks we heard about wireless troubles from our customers. Now a few days of troubleshooting later, i don't any idea why this would happen.Our Wireless Controller is an WLC4404 with software Rev. 7.0.220.0 the controlle...
HI,We have two Cisco Wireless Controller 4404 with the IOS Version 7.0.220.0 and a lot of accesspoints (ca. 170). Now i wan't to reboot a group of Accesspoints where i found over a filter... Is this possible?Or how can i reboot all the AccessPoints a...
Hi deshtikypshaq
Ok now i tried your configuration recommendations
After i gave the link-local address i was able to exchange the eigrp route to HUB02 but not with HUB01.
And i'm not able to ping HUB01 over the link-local or the real address... ...
Hi deshtikypshaq
First thanks for your reply!
We just try to do a DualStack Configuration over an IPv4 tunnel do you think this is possible?
We tried your configuration hint but with no better result than before, the LOG continous to tell the encapsu...
Hi GeorgeThanks for your reply!Now we restarted the WLC's and it seams the problem is solved, but we don't no why :SI would think about your tip with adjusting the MTU size of the EAP packet... I hope it solves the problem with the to big packets... ...
