Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I set up NAT, with a DHCP pool (15-20 addresses) on a simple LAN on eth0/1. Static IP's (five of them) 66.60.185.18 - .21.WAN on eth0/0, LAN on eth0/1, eth0/2 not used at this time (DMZ). I set up a static NAT for .20 to a FTP server and .21 to a vid...
Per se my SIP delay issues from inbound-only (outbound OK) SIP traffic, up to 60 seconds to originate an audio call, I'm thinking its cuz of the 1:1 mapping in place for the SIP gateway to a WAN IP. Someone else made this decision, I think they're wr...
I have a LAN (10.1.100.x), WAN (outside), and a DMZ (10.1.10.x) running off a ASA 5510.Rather than using NAT, how can I bind static IP's directly to devices on the DMZ (exposing them on the Internet, thereby) instead of using NAT to the 10.1.10.x hos...
Not really an network guy so bear w/ me. I've been running a preconfig environment of an ISR 2921 with its own vlan, WAN is an single ethernet pipe incoming.I need to introduce the ASA5510 into the equation, however some questions abound:- We have a ...
Thanks to all for helping - Question....on my LAN, I am seeing blockage between my dhcp clients and the host that is 10.1.100.150 NAT'd to one of the statics.In other words I'd like full traffic wide open between my LAN clients, and the host NAT'd.Or...
Thanks Jon!I have a bank of usable IP addresses (only about 8-10), and they are on the same subnet as the WAN interface.Assume I want to have an internal DMZ zone with internal subnet (10.1.10.x), but at the same time have some sort of way to bind an...
Thanks for replying, Richard, appreciate it!Basically I have a ISR2921 router and ASA5520, planned for deployment, but to get the network up for some preliminary webserver connections, I lit up the ISR2921 with software-mode firewall. I knew I would ...
