cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
421
Views
0
Helpful
1
Replies

ASA 5510 - 1:1 IP mapping ignore inspection rules? SIP delay!!

davidbirchell
Level 1
Level 1

Per se my SIP delay issues from inbound-only (outbound OK) SIP traffic, up to 60 seconds to originate an audio call, I'm thinking its cuz of the 1:1 mapping in place for the SIP gateway to a WAN IP. Someone else made this decision, I think they're wrong to do so. I figure revert it back to SIP ports under the ACL and be done w/ it. Inspection rules apply to 1:1 as well?


refer to thread: https://supportforums.cisco.com/thread/2050778

I have this 60 scond delay on all inbound SIP calls, trying to discern whether its the firewall or SIP gateway.

1 Reply 1

balajirajahpb
Level 1
Level 1

Hi David,

Do you have SIP service policy/Global timeout enabled on your firewall. Can you share the diagram shows the conection details

Regards

Balajirajah P B

Review Cisco Networking for a $25 gift card